The Korda Interceptor is a new distance surface controller. The design of the controller allows you to change the weight of the controller without having to break down your setup. The controller has a self orientating high viz sight, is very aerodynamic for long range casting with minimal tangles and is made with a low visibility surface colour plastic.
To setup one up you will need a Korda Interceptor and a Korda size 11 ring swivel.
Thread your mainline through the rigid tube.
Slide the soft insert onto your mainline and push the rigid tube inside it.
Now tie on the size 11 ring swivel using a Palomar knot. Double over the end of your mainline and pass it through the eye of the swivel.
Tie and overhand knot around the swivel with the doubled over section of your mainline.
Then pass the swivel through the loop created in the doubled over mainline once the overhand knot has been formed.
Moisten the knot and tighten it down slowly, before trimming the tag end.
Gently pull the swivel into the soft insert.
Locate the slot on the side of the interceptor body and place your mainline in the slot.
Slide the interceptor down the rigid tube until is sits firmly on the soft insert.
The Interceptor is now ready for you to attach your hooklink and cast out.
Give it a go. To purchase any of the items shown please click on the above links.