Carp Catchers Blog

Guru produce two types of inline feeders, the Guru Inline Method Feeder and the Guru Inline Pellet feeder. They are setup the same way but are used with different bait loaded onto the feeder. The Guru Pellet feeder is designed to be used with soft scaulded pellets as loose feed in the feeder and the Method feeder is to be used with a method mix moulded around one side of the feeder, both giving similar presentations with different baits. Both of the Guru feeders come in two sizes, 24 grams and 28 grams.

Step 1.

Remove the small tail rubber and swivel from either end of the feeder, like so.

Step 2.

Now thread you mainline through the tail rubber (Narrow end first) and the feeder.

Step 3.

Attach the swivel supplied to the end of your mainline using a Palomar knot.

Step 4.

Push the tail rubber back into place at the top of the feeder, then pull the swivel back into the bottom of the feeder.

Now to attach the hooklink. If you buy Guru’s readymade hair rigs they will come with a loop tied in the end but if you like to tie your own then tie a loop in the end using a Figure of eight loop knot.

Step 5.

Pass the looped end of the rig though the swivel of the feeder.

Step 6.

Now pass the hook though the loop at the end of the rig.

Step 7.

Pull the hook end of the rig until everything tightens down. The rig will look like this.

Your feeder is now ready to be baited and cast out.

Give them a go. To purchase either the pellet or method feeders click on the the above links.

Dave

The New Rig Marole Bore Rings are an ingenius idea to make bait attachment, fast, simple and effective. No more searching for that lost baiting needle or dropping your last bait stop on the floor, you simply have to screw your bait into place. The Bore Rings are designed to be used with D-rigs, Chod rigs, Blowback rigs etc, basically any rig you would normally have a ring on the rig which your bait is attached to.

The Bore Rings are very versatile in the range of baits they can accomodate. The Bore Rings are ideal for anything from Boilies, Pop ups, Corkball pop ups, Pellets, Artificial Baits, Maize, Nuts and other hard particle baits.

The simple idea of the Bore Rings enables anglers to quickly change their baits without the need for baiting needles, bait stops, rig rings or bait floss.

The rig shown is one of many applications for the Bore Rings, they can even be used for zig rigs and surface fishing. These have been tried and tested, your bait will not come off on the cast.

Give ‘em a go! To purchase click on any of the above links.

Tight Lines

Dave

I had another good session recently banking 4 fish, 3 of which were 20lb+ including this immaculate 28lb Common. The fish fell to my standard Blowback Rig set up consisting of a Korda Wide Gape Hook, Korda Weed Green Shrink Tube and Atomic Jel-E-Wyre hooklink with an Armaled Locjaw Safety Leadclip, 3oz Korda Pear Swivel Lead and 3 ft of ESP Leadcore. The hookbait was a 20mm snowman presentation topped with a 14mm Solar Fluoro Pineapple pop-up. The fish were all landed with the aid of the new Korda Subline.

Tight Lines

Dave

The Atomic Tackle Choppa Droppa is a safety helicopter lead system, offering a setup that can be fished in or around weed that will allow the lead to drop should it become snagged.

In this demonstration I used the Atomic Tackle Choppa Droppa Ready Rigs but Atomic do sell a Choppa Droppa Kit which enables you to use your own choice of leadcore or leader.

Step 1.

Pull the micro bore bead off the small leadcore link, then thread on your lead followed by the micro bore bead onto the small leadcore link.

Step 2.

Using a baiting needle pull the leadcore link through the Choppa Droppa clip.

Leadcore link pulled through.

Step 3.

Now tear a small piece off a PVA nugget and roll it between your fingers.

Step 4.

Push the PVA stop into the loop at the end of the small leadcore link and pull it tight against the clip. Attach a rig and the setup is now ready to cast out.

Tight Lines

Dave

The autumn period has to be one of my favourite times of year for fishing. The leaves are falling off the trees, a lot of anglers start to stay at home due to colder conditions and the fish get on the munch before the impending winter, as this recent capture of mine proves during a session on one of my syndicates. Its a fish known as the “Dumpy Mirror” and weighed in at 34lb exactly. The fish fell to a corkball pop up fished on a Chod Rig consisting of an ESP Stiff Rigger Hook, Gardner Tripwire and 9 ft of ESP Original Camo Leadcore. 

Get out there and bag an autumn whacker!

Tight lines

Dave

Here’s a handy little tip for getting really neat knots. Instead of using saliva to bed down knots use a dab of Lipsalve which is easily obtainable in chemists or supermarkets and comes in handy tackle box size containers. It will give you a much tighter knot with no line burns or pig tails.

Best Fishes,

John

Heres a nice common carp weighing in at 26lb 8oz. The fish fell to a snowman hookbait with a Solar Juicy Pineapple Fluoro pop-up topping the combination. I have had a lot of success this year using snowmans with bright fluoro pop-ups.  The rig was my usual Blowback Rig consisting of  Atomic Jel-E-Wyre  hooklink material and a Korda Wide Gape Hook in conjunction with a 3oz pear lead, ESP Bulk Spool Leadcore  in Original Camo and an Armaled Lead Clip.

Tight Lines

Dave

We now have the Solar Weed Effect Range in stock. First up we have The Solar Weed Effect Hooklink which looks and feels like weed. The Weed Effect Hooklink is tied with a size 6 Longshank Hook, but has a unique system which makes hooks interchangable, so any size or pattern of hook can be used. The soft feel anti tangle fibres will absorb dips and flavours or lake bed odours for either increased attraction or concealment. For more information or to purchase please click on the above link. The Solar Weed Effect Leadcore Leader has the same realistic soft touch anti tangle weed effect fibres and comes in 35lb B.S. 1 metre lengths with spliced loops at each end. The Solar Weed Effect Leads have colour coded tags attached to the swivel to differentiate between sizes and feature the same fibres as the above products. For more information or to purchase please click on the above links.

A lot of carp anglers struggle to tie chod rigs, so ESP have done something about it. The ESP Chod Rigs are tied with ESP Stiff Rigger Hooks, Bristle Filament and a smooth Japanese Uni Link Ring Swivel. These look really well tied and uniform guys and you get three in a pack at a decent price. To check them out or to buy please click on the above link.

                                     Solar Weed Effect Hooklink

                                Solar Weed Effect Leadcore Leader

                                     Solar Weed Effect Leads

                                                ESP Chod Rigs

Best Fishes,

John

Customer Dodge Green had a nice result from Gigantica recently. As most of you know Gigantica is quite a hard water and the week that Dodge was there only 4 carp were landed with 5 lost. The nice 39lb 8oz mirror below fell to Dodges rods after only 6 hours fishing, with another lost on the last night. The winning tackle included 12lb Pro Clear  tied to a 4ft 24lb Grand Max leader and a 3oz Atomic Inline Lead. The rig was tied blowback style with Korda Supernatural  in gravel brown tied to size 6 Nash Fang Twister  hook with two Korda Sinkers  on the hooklink. Bait was from Deception Baits. Well done Dodge!!

Best Fishes,

John

Customer Adam Holmes has had the big one out of his local lake. Here’s what Adam had to say :-