Step 1.

Remove the small tail rubber and swivel from either end of the feeder, like so.

Step 2.

Now thread you mainline through the tail rubber (Narrow end first) and the feeder.

Step 3.

Attach the swivel supplied to the end of your mainline using a Palomar knot.

Step 4.

Push the tail rubber back into place at the top of the feeder, then pull the swivel back into the bottom of the feeder.

Now to attach the hooklink. If you buy Guru’s readymade hair rigs they will come with a loop tied in the end but if you like to tie your own then tie a loop in the end using a Figure of eight loop knot.

Step 5.

Pass the looped end of the rig though the swivel of the feeder.

Step 6.

Now pass the hook though the loop at the end of the rig.

Step 7.

Pull the hook end of the rig until everything tightens down. The rig will look like this.

Your feeder is now ready to be baited and cast out.

Give them a go. To purchase either the pellet or method feeders click on the the above links.

Dave

Step 1.

Take some standard off the shelf pellets, such as, Trout or Halibut pellets and cover them in boiling water for a couple of minutes before draining the water off.

Check the pellet is sufficiently softened, if not repeat the process with boiling water until they are the right consistency.

For the purpose of this demonstration I only prepared enough pellet for one feeder. If you are planning a day session I would suggest you prepare as much as you think you may need.

Step 2.

Attach the feeder to your mainline, followed by a rig and your choosen bait. I would suggest something that matches the pellet in the feeder.

Step 3.

Partly fill the feeder with the scaulded pellet.

Step 4.

Then place the hookbait in the feeder like so.

Step 5.

Now top up the feeder and compress slightly. Make sure not to compress the pellets too much though, as you want them to loosen and release the hookbait once on the lake bed.

Your feeder is now loaded and ready to cast out.

The feeder will land on the lakebed with the pellet still intact.

But after a minute or so and a gentle pull back of the feeder from the rod it will release the pellet and your hookbait.

This type of presentation is perfect for any waters where weed is present or you are fishing in a greater depth than normal. Although it will work perfectly on all waters.

Give it a go.

Dave

Guru Micro Lead Clips

The leads I used for the purpose of this demonstration were the Guru Square Leads.

Step 1.

Thread your mainline through the tail rubber and then the lead clip.

Step 2.

Double over the tag end of your mainline and pass the loop through the eye of the size 11 swivel provided.

Step 3.

Now tie an overhand knot with the doubled over section of your mainline but don’t tighten it yet.

Step 4.

Pass the swivel through the loop created by the overhand knot.

Step 5.

Now moisten the knot and gently tighten it down.

Step 6.

Pull the lead clip down over the swivel until you hear it click into the clip.

Step 7.

Now clip your lead/feeder on and slide the tail rubber over the lead clip so the angled edge sits the right way on the clip.

All you need to do now is tie on your rig and your ready to cast out. But before doing so make sure the clip is working correctly and the lead will discharge easily. You are now fishing a carp safe set up.

Tight Lines

Dave