Guru Micro Lead Clips

The leads I used for the purpose of this demonstration were the Guru Square Leads.

Step 1.

Thread your mainline through the tail rubber and then the lead clip.

Step 2.

Double over the tag end of your mainline and pass the loop through the eye of the size 11 swivel provided.

Step 3.

Now tie an overhand knot with the doubled over section of your mainline but don’t tighten it yet.

Step 4.

Pass the swivel through the loop created by the overhand knot.

Step 5.

Now moisten the knot and gently tighten it down.

Step 6.

Pull the lead clip down over the swivel until you hear it click into the clip.

Step 7.

Now clip your lead/feeder on and slide the tail rubber over the lead clip so the angled edge sits the right way on the clip.

All you need to do now is tie on your rig and your ready to cast out. But before doing so make sure the clip is working correctly and the lead will discharge easily. You are now fishing a carp safe set up.

Tight Lines

Dave

For this demonstration I used Korda Safe Zone Sinking Rig Tubing, Korda Safe Zone Run Rig Rubbers, Korda Size 8 Swivels, Korda Ring Clips, Korda Silicone Sleeves and a Korda Pear Lead.

Step 1.

Thread your mainline through your desired length of rig tubing.

Step 2.

Now thread your mainline through the ring on one of the Korda Ring Clips.

Step 3.

Then thread on the Korda Run Rig Rubber and push the rig tubing into the narrow end of the rubber.

Step 4.

With the tag end of you mainline tie a Palomar knot. Double over the tag end and pass it though the eye of a size 8 swivel.

Now tie an overhand knot with the doubled over section of your mainline.

Then pass the swivel through the loop created by doubling over the mainline.

Moisten the knot and tighten it down gently before trimming the tag end.

Step 5.

Pull the swivel inside the Run Rig Rubber.

Step 6.

Now push a silicone sleeve over the swivel of your choosen lead and hold it down so the top eye of the swivel is exposed.

Step 7.

Clip the lead onto the ring clip.

Step 8.

Now slide the silicone sleeve back up over the eye of the swivel and over the ring clip.

Notice how the eye of the swivel attached to the lead has been left exposed, this is to allow the setup to lie flat on the lake bed.

To change to lead all you have to do is slide the silicone sleeve back down and swap the leads.

All that is left to do is attach your rig by either using a Korda Kwik Link or tying it directly to the swivel.

Give it a go.

Dave