Tight Lines

Dave

The rods did’nt go out till first light and I got my head down for a very much needed few hours sleep. After no action during the day except the usual bream I proceeded to place the rods back out on the spots for the evening with a handful of freebies over each rod. The left hand rod was waded along the margin and placed gently on top of the soft silt. The middle rod was cast to the far margin snag next to the lillies and the right hand rod was again placed on the open water spot.

The setup I was using consisted of Armaled LocJaw Safety Lead Clips and Armaled LocJaw Tail Rubbers with 3oz Korda Pear leads. A 7 inch length of Sufix Stiff Silt with 2 inchs stripped back, a Korda Wide Gape  hook size 8, a small piece of silicone tubing on the shank of the hook and an extended curved shank using Korda Shrink Tubing

At around 12 pm I had a run on the middle rod resulting in a 14lb mirror and after returning the fish to the water I recast the rod and got my head down. I was woken during the night again by the middle rod but this time a small bream was the culprit. The following morning the margin rod was fizzing and bubbling away and I knew another take was on the cards. About 10 minutes later it tore off and I was in again. This time the fish felt a little better and after a very hard fight with several big lunges for the bush I was fishing upto she was mine. A modest 17.5lb common carp was quickly weighed, pictured and returned.

Later that day I lost a good fish on a zig rig after spending an hour or so observing the fish and the route they were taking through my swim. The rod had been placed a few inches under the surface along a route the majority of the carp appeared to be taking.  After that I recieved no further action and packed up mid afternoon.

Although there were no big’uns , it was nice to get a bend in the rods.

Tight Lines

Dave

The rig components used in this demonstration were Ultima Power Zig hooklink, ESP Big T Carp Hook and ESP Silicone Tube .

Step 1.

Cut the Ultima Power Zig to your desired length.

Step 2.

Now tie a small overhand loop in one end for your hair stop and thread on your desired choice of pop-up or foam followed by a bait stop.

Step 3.

Then cut a small section (2-3mm) of silicone tubing and thread it onto your zig hooklink.

Step 4.

Now thread the point of the hook through the silicone tubing heading towards the bait and set the hair length at about 2-3mm with the tubing sitting at the top of the shank.

Step 5.

Now tie a knotless knot and don’t forget to whip the hooklink back round the knot once on the way towards the eye to prevent it from slipping.

Step 6.

To finish the zig rig off tie a figure of eight knot at the other end.

The zig rig is now finished and ready to use.

If you are not sure about any of the knots use the Carp Catchers Blog search bar to navigate to the relevant knot

Tight lines

Dave

Finally we were off the mark with a nice common carp. The take came to a combi link rig tied with Rigmaroles  Hydro-Link Silt  with two pieces of  Enterprise Pop-Up Sweetcorn  as a hookbait. In the afternoon we tried zig rigs on top of the gravel bars to no avail. We spodded out about another 6 kilos of bait for the coming night. We added some sweetcorn and  Carp Company Icelandic Red Cranberry & Caviar Freezer Boilies  to the spod mix.  At about 5.00pm I had another bite on the island rod which was cut off after about 20 seconds. Another cut off on the same rod about two hours later had Gary and I pulling our hair out. We both tied on the heaviest Nylon leaders we could (leadcore and braid leaders are banned) in an effort to combat the cut offs. Gary had one cut off and landed one carp that night which weighed 19lb plus so now we were in the running. Next morning saw us land another 18lb pluser, which put us well into contention. It was not to be though and at 12.00 the hooter sounded to end another BCAC qualifier. Had we landed any one of the fish we lost we would have qualified.

Best Fishes,

John

Best fishes,

John

The zig rig is a statically fished suspended bait on an extra long hooklink. The most popular hooklink material for zigging and floater fishing is Drennan Double Strength .  

The use of zig rigs is a very productive tactic on days were the fish are up in the water but is a tactic that is normally overlooked due to the difficulty of setting them up and getting them out into the lake due to tangling. Tangling can be reduced by the use of soluble rig foam or better still a small mesh bag filled with floaters nicked onto the hook. Kordas’ Boilie Funnel Web PVA System  is particularly good for making small mesh bags and melts quickly with no residue.

Setting up a zig rig is easier than many anglers think, a simple lead clip will be more than enough in terms of a lead set up.  Firstly you need to find out the depth of the area you wish to fish. To decide these areas observe the carps patrol routes as they cruise just below the surface.

Once an area and its’ depth has been selected, the next step is to decide the depth under that water you wish to present your bait. As I said earlier this can be determined from observing the fish you’re targeting  and estimating how far below the surface they are. Now you have decided on the depth you wish to fish you need to tie your hooklink to the correct length. For example, if you have choosen to fish an area that is 8ft deep and the fish are cruising about a foot under the surface then you need to tie up a 7ft hooklink. Once you’ve tied up your hooklink you’re ready to go.

A few tips that might help with using zig rigs.

Lay the hooklink down on the ground or coil it round in the bottom of a bucket to cast the rigs out.

Coiling the hooklink up and tying it in a coil with pva tape can make casting easier. 

Try as many different colours baitwise as possible to determine the best colour to use, black foam works well as it stands out against a light sky. Gardner Tackle do a good range of  Zig Rig Foam  including black.

If the fish are up in the water try and observe what they are eating if anything, especially this time of year as there are a lot of fly hatches which will get the fish feeding on food items up in the water. Remember if there is a fly hatch happening and the fish are feeding use a small piece of dark foam, flies aren’t bright yellow!

I believe that colour is the key with zigs and not the flavour, you are trying to imitate natural food items or induce a take from a curious carp, you are not normally trying to get the carp feeding on free offerings. Although feeding free offerings can be a good tactic on heavily stocked waters. Spod a sloppy mix that doesn’t contain many free offerings over the top to bring carp into the swim and get them feeding up in the water where the zigs rigs have been placed. 

Hook choice can be a crucial factor. You need a strong, small, sharp hook that will sit at the optimum angle two patterns to try are the ESP Stiff Rigger , especially for pop ups or the ESP Big T Carp Hook  for foam. A size 10 or 8 should be sufficient.

Lead size is also crucial, use the lightest lead you can to achieve the distance you need. The reason for the light leads is so that you do not bump the fish off while playing it on a long hooklink

Give zig rigs a little thought and adapt them for your water, you could be pleasantly surprised with the results.

Tight Lines

Dave