Carp Catchers Blog » Carp Fishing Knots

5 Turn Clinch Knot

admin — Fri, 17 Jul 2009 12:15:30 +0000

This Carp Catchers Blog is going to show how to tie the 5 Turn Twice Through The Eye Clinch Knot. The Clinch Knot is an improvement on the blood knot. It was devised by carp fishing pioneer Jim Gibbinson and is a real belt and braces knot. The 5 turn clinch knot is normally used to attach swivels but there is no reason it could not be used to attach hooks. Ok carp catchers lets get started.

Step 1

Thread your line through the swivel

Step 2

Thread it through again

Step 3

Pull the tag end through about 6” from the swivel and lay alongside the mainline or hooklink

Step 4

Whip the tag up over the mainline or hooklink back towards the swivel as per photo. Do this 5 times

Step 5

Tread the tag end through the loop created at the swivel end

Step 6

Thread the tag end through the loop created at the opposite end to the swivel

Step 7

Moisten and carefully bed down the knot. Cut off tag end

5 Turn Clinch Knot

Best fishes,

John

Fluorocarbon Knots

admin — Mon, 15 Dec 2008 11:28:10 +0000

Some interesting news for those of you experiencing problems with knots for fluorocarbon. One of the big American line manufacturers has done some research on knots and fluorocarbon. They found that one of the most popular and strongest knots the palomar, weakened fluorocarbon by up to 30%. Gardner Tackle who have considerable knowledge on fishing lines, suggest using the blood knot, which is usually considered one of the weakest fishing knots. So you might want to consider doing some knot tests yourselves armed with this information.

Best fishes

John

The Figure Of Eight Loop Knot

admin — Mon, 24 Nov 2008 12:25:31 +0000

The Figure Of Eight or Double Overhand Loop Knot is an extremely strong loop knot with many applications. Below is a step by step photographic sequence showing you how to tie it.

Step1

Choose your hooklink material and cut the desired length. I have chosen Sufix Camfusion 15lb for this demonstration.

Step 2

Double the hooklink over and form loop to the approximate size that you require for your rig.

Step 3

Form another loop in the doubled over hooklink material

Step 4

Thread the end of the first loop through the second loop

Step 5

Thread the end of the first loop through the second loop again

Step 6

Gentley tease the knot down, this is the figure of eight

Step 7

Moisten the knot with saliva and bed down then trim off the tag end. The finished Figure Of Eight Or Double Overhand Loop Knot.

Hope this is of use, any comments would be welcomed and appreciated.

Best fishes,

John