Carp Catchers Blog

The  MCF Dumper Lead Clip  is a very clever and innovative lead clip that is guaranteed to drop the lead in the event of a fish snagging or weeding you up. The tapered sleeves incorporated in this lead clip system help to minimise tangles. This Carp Catchers Blog will show you step by step how to set it up.

These can be set-up with any form of leader or tubing but for the purpose of this demonstration I used a ready spliced leadcore leader.

Step 1.

Using a bait needle thread the small rubber sleeve onto your leader or tubing.

Step 2.

Now you need to pass your spliced leader loop through the metal loop on the lead clip. Or tie on your mainline with your rig tubing already threaded on (Miss steps 3 and 4).

Step 3.

Then pass the lead clip through the loop in the end of your leader.

Step 4.

Pull the leader to secure the loop around the metal loop.

Step 5.

Push the small rubber sleeve over the metal loop.

Step 6.

Now push a baiting needle through the longer sleeve from next to the metal hook out of the tapered end and latch the baiting needle onto your choosen rig.

Step 7.

Once you’ve pulled your hooklink through loop it over the metal hook.

Step 8.

To finish the setup pull the hooklink tight and clip on a lead.

The lead should not eject on a normal force cast, however if a distance cast is required I would suggest securing the lead in place with PVA tape.

If you are using rig tubing then adapt the instructions accordingly.

Tight Lines

Dave

Its getting to that time of year again when maggots are becoming more widely used due to them being such an effective winter bait. Have a go at tying this rig and see how you get on.

The components used in this demonstration were the Korda IQ2 Xtra Soft Fluorocarbon , Korda Wide Gape  hook size 8 and  Korda Micro Rig Swivel.

Step 1.

After cutting your required length of fluorocarbon tie on a Korda Wide Gape using a knotless knot making sure to whip round the shank twice on the way back down to the eye. 

Step 2.

Now thread a micro rig swivel onto the tag end above the hook.

Step 3.

Then pass the tag end through the back of the eye to the front and trim the tag end down to about 3-4mm. This will have created a D shape on the back of the shank for the swivel to move on.

Step 4.

Holding the hooklength out of the way slowly blob the tag end with a lighter to secure it in place. Make sure not to burn the hooklink as this will damage the fluorocarbon and increase the chance of it breaking. Also take care not to burn yourself.

Step 5.

To finish the rig tie a figure of eight knot in the other end setting the desired length of rig you require and trim the tag end.

The finished rig should look like this.

This rig works best with a large bunch of maggots and a couple of imitation pop-up maggots to help counter the weight of the hook. This rig isn’t strictly a maggot rig and can be used with other baits as well. 

The knots used in this demonstration can be found in previous blogs by using the search bar on the top right hand side of the page.

Give it a go.

Tight Lines

Dave

In this Carp Catchers Blog we have one for the future. Customer Rob O’Brien sent in this photo of this gorgeous scaly mirror carp not a monster but who cares. Also notice how Rob has chosen a suitable background for his catch photo which really enhances the whole thing. Rig details are sketchy but a Korda Choddy  hook and a Korda IQ Hooklink  were involved.

Best Fishes,

John

After deciding to change waters for the coming winter and due to busy banks I’ve had a little bit of a confidence boost. On my first weekend session from late friday evening to early monday morning I had a bit of a result in the shape of 6 mirror and common carp to 21lb15oz. After turning up in the dark at 8.30 friday evening I opted for the north bank as I had been told it was free of any other anglers. After watching the water for nearly 2 hours I decided to fish up the dam end in the the deeper water or what was left of it anyway as this is where I’d seen the carp showing the most . The reservoir serves the purpose of topping up the Grand Union canal so the water levels can get quite low at times.

During my session I banked 6 carp to 21lb 15oz from 3 different spots using  Baitcraft T1  boilies over a spread of bait which included a spod mix of hemp, Solar Pure Bait BYT and crushed T1s over one of my rods. Most of the bites came during the hours of darkness which meant I had to have all my spots marked up to get them back on the spots in the darkness.

The rigs I used consisted of 15lb Korda IQ2 tied to 2 inches of stripped Sufix Stiff Silt with a size 6 Korda Wide Gape Hook, a small piece of shrink tubing over the eye and tied blowback style.

Tight Lines

Dave

(I should have turned my head torch off for the night time shots, but had forgotten while sorting the self takes. Luckily they didn’t turn out too bad.)

Im a big fan of spreading boilies over a larger area to encourage carp to keep moving, especially as the temperature is beginning to drop. Its helps your rigs work more effectively as the carp aren’t stopping to feed, they are picking up the boilies on the move. It also leaves less chance of the fish sussing your baited area. Tightly baited spots do produce fish and I will also use them in given situations but I believe that a spread of bait is far less obvious as the carp only come across the odd boilie over your area. It can also help produce takes faster as the carp are more likely to pick up your bait if they come across it.

This is a nice clean mirror carp caught over a spread of 20mm Baitcraft T1 Freezer Boilies on a recent overnighter where I put all three rods in the same area and spread 150 baits over the three of them. The rig I used a blowback combi rig tied with 15lb  Korda IQ Fluorocarbon   and 2” of stripped Sufix Stiff Silt  to a size 6 Korda Wide Gape Hook .

Give it a go.

Tight lines

Dave

Customer Sean Bown and his friends had a fantastic haul of French carp recently from The Sanctuary. Sean reports

 “Hi John,
A top time was had by all at the Sanctuary in France with 54 fish being banked between the four of us, with 5 40′s and some 20+ 30′s, awesome!!!!
I accounted for 14 of the haul with one 40 and nine 30′s three mid 20′s and one at 12.”

Baitcrafts T1 Freezer Boilies  purchased from us in both 16 and 20mm accounted for all of Sean’s fish. His rigs were constructed wth size 5 ESP Big T hooks tied to either Korda Hybrid Soft Coated Braid  or  Korda Supernatural  hooklinks. Nice one Sean, really good looking fish. Photos’ are pukka too.

                                                                                   38lb 8oz Common Carp

                                                                                   41lb 8oz Mirror Carp

Best Fishes,

John

Martin Deathridge had a nice clean mirror carp from Bluebell Lakes Swan lake last week. Weighing 29lb 12oz Martins mirror was tempted from the edge of a weed bed at 70yrds range. Martin was using 18mm  Mainline Cell Freezer Boilies  scattered over a wide area. His hookbait was a snowman with a Cell bottom bait balanced out with a 10mm  Mainline Hi Visual Pineapple Pop Up. The rig Martin used was tied with  Nash Missing Link  in 25lb tied to a size 5  ESP Curve Shanx  hook. Nice one.

Best Fishes

John

Here’s a little Carp Catchers tip to help pin that mainline down on the lakebed. The Korda Sinkers  were developed to keep rigs pinned down, but try spacing out 3 or 4 of the large size along your maniline at the rig end to really sink your mainline. I’ve got them on my set up and they really work well sinking your mainline straight away, even quite heavy braided mainlines. For more information or to purchase please follow the above link.

Best Fishes,

John

Customer Tony had a nice result from Wold Lake recently. Using  Mainline Hi Visual  Pineapple pop ups Tony had two nice mirror carp of 17lb and 24lb. Tonys’ rig consisted of  Korda IQ Xtra Soft  tied to a size 8  Korda Kurv Shank  hook. Well done Tony!!

Best Fishes,

John

James Kirk really had the common touch recently with this stunning 34lb common carp, just look at the tail on it. Fishing to the back of a weed bed at 35yrds range James used a critically balanced tiger nut hookbait with a mesh bag of  TFG PVA Friendly Tiger Nuts . James’ rig was tied with a size 4 Atomic Claw Hooks  to an ESP Striptease Hooklink . Well Done James, a real stunner!!

Best Fishes,

John