Guru Micro Lead Clips

The leads I used for the purpose of this demonstration were the Guru Square Leads.

Step 1.

Thread your mainline through the tail rubber and then the lead clip.

Step 2.

Double over the tag end of your mainline and pass the loop through the eye of the size 11 swivel provided.

Step 3.

Now tie an overhand knot with the doubled over section of your mainline but don’t tighten it yet.

Step 4.

Pass the swivel through the loop created by the overhand knot.

Step 5.

Now moisten the knot and gently tighten it down.

Step 6.

Pull the lead clip down over the swivel until you hear it click into the clip.

Step 7.

Now clip your lead/feeder on and slide the tail rubber over the lead clip so the angled edge sits the right way on the clip.

All you need to do now is tie on your rig and your ready to cast out. But before doing so make sure the clip is working correctly and the lead will discharge easily. You are now fishing a carp safe set up.

Tight Lines

Dave