Carp Catchers Blog

The Solar Quick Change PVA Bag System is ideal for anglers who use PVA bags for the majority of their angling. The system will ensure you don’t lose the bag on the cast while improving casting distance and accuracy. The system is designed to be anti tangle and works with any inline lead.

For the purpose of this demonstration I used a Korda Flat Pear Inline Lead, Solar Contour Super Supple Rig Tubing and Korda Size 8 Ring Swivels  was used between the helicopter beads for the rig to be attached to.

Step 1.

Thread your mainline through your desired length of the Solar rig tubing.

Step 2.

Now thread 1 of the beads provided with the Solar PVA System onto the rig tubing followed by the Korda Ring Swivel followed by another bead. If you’re using mainline straight through there is silicone tubing provided for the beads to the grip. If you’re using leadcore then please ensure all beads can be pulled free of the leader to ensure the lead will be lost in the event of your line breaking. Tie or loop your hooklink to the ring swivel.

Step 3.

Now thread on one of the sleeves provided and push the tubing securely inside.

Step 4.

Then gently push the insert out of your choosen inline……

…..and thread it onto your mainline.

Step 5.

Tie a Figure Of Eight Loop Knot  in the end of your mainline and attach the Solar quick change PVA bag clip like so.

Step 6.

Now pull the lead over the clip followed by the sleeve and rig tubing. The finished setup should look like this.

All you have to do to attach a PVA bag is to pull the clip out of the bottom of the lead and hook a PVA bag on before pulling the clip back inside the lead. Then just thread the hook through the mesh of the bag and your ready to cast out.

This set up is particularly well suited to adding freebies with the Mag Aligner Rig and really comes into it’s own during the winter months.

Give it a go.

Tight lines

Dave

A lot of anglers prefer to use inline leads for most of their fishing but certain fishing situations dictate that it isn’t possible to use them due to excess weed growth which means a setup which releases the lead on the take is needed, well here’s how to set up an inline lead that will drop off on the take. The rig components used in this demonstration were a Korda flat pear inline lead, a  Korda Safe Zone Kamo Leader  and  Korda Safe Zone Tail Rubbers .

Step 1.

Using a good set of pliers remove the eye of the swivel furthest from the leader.

Leaving just the swivel barrel and the eye attached to the Korda Safe Zone leader loop, I know in past demonstrations of this setup by others the whole swivel have been left but Ive found it takes a lot less to discharge the lead this way especially with slower takes.

Step 2.

Now slide a tail rubber up the leader.

Step 3.

Using the pliers again trim a small length of the plastic insert from the inline lead, making it even easier to drop the lead.

Step 3.

Now attach a  Korda Stick Clip  to the eye of the swivel.

Step 4.

Then push the swivel into the bottom of the lead, making sure it goes in barrel first. It will just about sit comfortably in the insert.

Step 5.

Now slide the tail rubber onto the trimmed down plastic insert and pull it tight making sure it holds the swivel in place.

The finished setup should look like this and should discharge the lead on the take making it easier and safer when fishing for big carp in weedy waters.

Tight Lines

Dave