These are the components that I used to tie the rig.

Step 1

To tie the Multi Rig it is best to use a coated braid in this instance I am using Sufix Camfusion

Step 2

Cut a length of the Camfusion and tie a figure of eight loop knot (see previous blog). The loop should be approximately 45mm long.

Step 2

Thread the loop through the Gardner Longshank Incizor hook

Step 3

Thread one of the small Korda  rig rings onto the hookshank. The rig ring on the shank of the hook is to prevent the hooklink catching and possibly parting in the join in the eye of the hook.

Step 4

Thread one of the Rigmarole 4mm Rig Rings  onto the loop

Step 5

Thread the hookpoint through the loop

Step 6

Tie a size 8 swivel to the other end of the hooklink with a figure of eight loop knot, moisten and bed down

Step 7

Position the D on the hookshank. A good starting place is midway between the hookpoint and the barb

Step 8

The finished rig

Step 9

Thread on a pop up of your choice, put some tungsten putty on the knot and you’re done.

There you have it The Multi Rig.

Best fishes,

John